
6 - 16 WiNG CLI Reference Guide
Parameters
Example
rfs7000-37FABE(config)#show captive-portal client on rfs7000-37FABE
Number of Hotspot Mobile-Units: 1
client {filter|on} Displays connected captive portal client information
• filter {captive-portal|ip|state|vlan|wlan}
– Specifies an
additional selection filter for getting table values
• {on <DEVICE-OR-DOMAIN-NAME>} {filter {captive-
portal|ip|state|vlan|wlan} – On AP/Controller or RF Domain
name
The following are common for the above:
• captive-portal {CAPTIVE-PORTAL|not CAPTIVE-PORTAL}
– Displays clients on the selected
captive portal
• CAPTIVE-PORTAL – Specify captive-portal name
• not CAPTIVE-PORTAL – Invert match selection
• ip {<A.B.C.D>|not <A.B.C.D>} – Selection by IP address
• <A.B.C.D> – Specify IP address
• not <A.B.C.D> – Invert match selection
• state [not[pending|success]
|pending|success]
– Selection based on state
• pending – Clients redirected for authentication
• success – Clients successfully authenticated
• not [pending|suucess] – Invert match selection
• vlan [VLAN-ID|not VLAN-ID]– Displays clients on given
VLAN
• VLAN-ID – Specify the VLAN number
• not VLAN-ID – Invert match selection
• wlan [WLAN|not WLAN] – Displays clients on given
WLAN
• WLAN – Specify the WLAN name
• not WLAN – Invert match selection
Comentarios a estos manuales